A4 Cabriolet Mk2
|
|
|
|
|
|
|
| 1 - | Retaining clip |
| 2 - | Seat height adjuster lever |
| q | Illustration does not correspond to design of RS bucket seat |
| 3 - | Seat height adjuster unit |
| Removing |
| – | Remove seat → Chapter. |
| – | Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
| – | Attach front seat to seat repair stand -VAS 6136-. |
| – | Remove backrest and seat pan (front) → Chapter. |
| – | Unscrew nut -5-. |
| – | Unscrew bolts -7- (2x). |
| – | Remove bolt -4-. |
| – | Detach seat height adjuster unit -3- and retaining plate -6-. |
| Installing |
| Installation is carried out in the reverse order; note the following: |
| – | Make sure retaining plate -6- makes contact with backrest frame at point indicated by -arrow-. |
| 4 - | Bolt |
| q | Tightening torque: 8 Nm |
| 5 - | Nut |
| q | Tightening torque: 12 Nm |
| 6 - | Retaining plate |
| 7 - | Bolts (2x) |
| q | Tightening torque: 8 Nm |
