A4 Cabriolet Mk2
Removing and installing rear side trim |
1 - | Side trim |
t | Removing |
– | Remove rear seat bench → Chapter. |
– | Remove rear seat backrest → Chapter. |
– | Remove trim panel → Chapter. |
– | Unclip centre section -4-. |
– | Unscrew bolt -5-. |
– | Reach into side trim -1- and unfasten side trim -1- at clips -2-, -7- and -6-. |
– | Detach side trim -1-. |
t | If side trim -1- is to be renewed: |
t |
– | Remove outer floor panel anchorage point → Chapter. |
t | Installing |
Note
t | After installing, make sure seal is properly in position over side trim. |
t |
– | Pull back clip -6- to slacken off clip -6-. |
– | Install side trim -1- in reverse order of removal. |
2 - | Clip |
3 - | Trim panel |
4 - | Centre section |
5 - | Bolt |
6 - | Clip |
7 - | Clip |