A4 Cabriolet Mk2
| Removing and installing floor covering |
| 1 - | Floor covering |
| t | Removing |
| – | Remove front seats → Chapter. |
| – | Remove rear seat bench → Chapter. |
| – | Remove sill panel trims → Chapter. |
| – | Remove A-pillar trim panels (bottom) → Chapter. |
| – | Remove foot rest → Chapter. |
| – | Remove foot rest bracket → Chapter. |
| – | Remove centre console → Chapter. |
| – | Unfasten wiring harness beneath centre console. |
| – | Unscrew bolts (2x) at air ducts -2- (2x) and detach both air ducts -2- (2x). |
| – | Remove bolts -3- (2x). |
| – | Fold up floor covering -1- lengthwise and take floor covering -1- out of vehicle. |
| t | Installing |
Note| t | Floor covering is liable to tear easily at cut-outs. Take care when fitting floor covering. |
| t |
| – | Install floor covering -1- in reverse order of removal. |
| 2 - | Air ducts (2x) |
| 3 - | Bolts (2x) |
