A4 Cabriolet Mk2
| Removing and installing parts of ABS system on front axle |
| 1 - | Hexagon socket head bolt |
| q | Tightening torques: 10 Nm |
| 2 - | Speed sensor |
| q | Left and right identical |
| q | Removing and installing → Chapter |
| q | Connector for speed sensor → Chapter |
| q | Grease all round with lubricating paste -G 000 650- before fitting in wheel bearing housing |
| q | Push into wheel bearing housing as far as it will go. |
| 3 - | Drive shaft with rotor |
| q | Checking rotor for dirt and damage → Anchor |
| q | If rotor is damaged, outer C.V. joint must be renewed together with rotor → Rep. Gr.40 |
| q | As replacement part, outer C.V. joint is supplied together with rotor. |
| 4 - | Speed sensor wire |
| q | Fit into retainers provided |
| 5 - | Hexagon socket head bolt |
| q | Always renew |
| q | Different versions available → ETKA |
| Vehicle must be standing on the ground when tightening |
| Tightening torques → Rep. Gr.42 |
