A4 Cabriolet Mk2
| 1 - | Protective caps |
| q | Insert into bearing bush |
| 2 - | Guide pins, 30 Nm |
| 3 - | Bleeder valve, 10 Nm |
| q | Before screwing in, grease thread with thin coat of lithium grease -G 052 150 A2- |
| 4 - | Protective cap |
| q | Push onto bleeder valve |
| 5 - | Brake caliper housing |
| 6 - | Retaining spring |
| q | Insert with both ends in the holes in brake caliper housing |
Note| The retaining spring must be pressed under the brake carrier after inserting into both holes. If incorrectly installed, the wear of the outer pad cannot be adjusted, and the pedal travel will be increased as a result. |
| 7 - | Bearing bush |
| q | Insert into brake caliper housing |
| 8 - | Brake carrier |
| q | Bolt to brake caliper housing |
| 9 - | Seal |
| 10 - | Piston |
| q | Apply a thin coat of lithium grease -G 052 150 A2- to piston |
| 11 - | Protective cap |
| q | Do not damage when inserting piston |
