audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate with rolling bearing > < Unscrewing

A4 Cabriolet Mk2

Screwing on
Screwing on
   
–  On installation, moisten rubber elements -B- slightly with soap solution for example to provide lubrication.
–  Insert rubber elements -B- in drive plate -A- as shown.
–  Insert drive plate -A- with rubber elements -B- in drive plate -C- as shown until it makes contact with compressor shaft.
  Note
Fig. shows rubber elements -B- of type “1”. Rubber elements -B- of type “2” are connected at top.
  A87-0626
–  Screw drive plate -C- onto compressor shaft -A- by turning it in direction of arrow -E-.
–  Tighten drive plate -C- to 30 Nm by turning it with a commercially available strap wrench (with fabric strap) in direction of arrow -E-. Provide support for compressor shaft -A- by applying counterhold -B- (e.g. socket wrench -T10001/10- from wrench set) to compressor shaft -A-.
  A87-0625

Removing and installing drive plate with rolling bearing > < Unscrewing