–
| Ensure correct positioning of restrictor -B- on installation (arrow on restrictor pointing towards evaporator). |
t
| Restrictor must be snugly positioned in refrigerant pipe |
–
| Check correct positioning of O-ring -C- (7.5 mm; 1.5 mm → Parts List) in groove. |
–
| Check type of seal at connections and refrigerant pipes (must be designed for same type of seal) → Chapter and → Parts List |
–
| Lubricate restrictor O-ring slightly with refrigerant oil before fitting. |
–
| Install refrigerant pipes such that they are not strained. |
–
| Tighten screw connection -A- to 15 Nm. |
Note Check position of refrigerant pipes after tightening screw connection (pipes must not make contact with other components). |
|
|
|