A4 Cabriolet Mk2
|
1 - | Gearbox housing |
q | Housing manufactured from aluminium or magnesium → Item |
q | With differential and flange shafts |
q | Removing and installing flange shafts → Chapter „Renewing flange shaft oil seal (left and right)“ |
q | Removing and installing differential → Chapter |
q | Removing and installing speedometer sender and drive wheel → Chapter |
q | Installation position of breather → Fig. |
q | Breather made of different materials for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
2 - | Torx socket head bolt |
q | Self-locking |
q | Always renew |
q | Black: only for aluminium gearboxes |
q | Bright metal: for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
q | Tighten to 35 Nm on aluminium gearboxes |
q | Tighten to 25 Nm on magnesium gearboxes |
3 - | Guide sleeve |
q | With O-ring and oil seal for input shaft → Chapter |
q | Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. |
q | Installation position: Oil drain hole points downwards. |
q | Guide sleeve is made of different materials for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
4 - | Dished spring |
q | Smaller diameter (convex side) faces guide sleeve |
5 - | Circlip |
q | Determining thickness → Chapter „Adjusting input shaft“ |
6 - | Ball bearing |
q | Removing and installing → Chapter |
7 - | Circlip |
q | Determining thickness → Chapter „Adjusting input shaft“ |
8 - | Input shaft |
q | Removing and installing → Chapter |
q | Dismantling and assembling → Chapter |
q | Adjusting → Chapter |
q | Servicing input shaft bearings → Chapter |
9 - | Bolt |
q | Black: only for aluminium gearboxes |
q | Bright metal: for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
q | Tighten to 25 Nm on aluminium gearboxes |
q | Tighten to 15 Nm on magnesium gearboxes |
10 - | Locking plate |
q | For multi-function sender |
q | Locking plate made of different material for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
11 - | Multi-function sender |
12 - | Connector for multi-function sender |
13 - | Bolt |
q | 10 Nm |
q | Black: only for aluminium gearboxes |
q | Bright metal: for aluminium and magnesium gearboxes |
q | For correct version, refer to → Electronic parts catalogue |
14 - | Cover for selector shaft |
q | Removing and installing → Chapter |
15 - | Locking unit for 5th gear and reverse gear |
q | Removing and installing → |
|