A4 Cabriolet Mk2
| 5th and 6th gear - exploded view of components |
| 1 - | 1st inner race for four-point bearing |
| q | Ball bearing end |
| q | Pulling off → Anchor |
| q | Driving on → Anchor |
| 2 - | Needle bearing for 5th gear |
| 3 - | Inner race for 5th speed selector gear |
| q | Pulling off → Anchor |
| q | Driving on → Anchor |
| 4 - | 5th speed selector gear |
| q | Pulling off → Anchor |
| q | Installing → Anchor |
| 5 - | Roll pin |
| q | Pressing out → Anchor |
| q | Pressing in → Anchor |
| 6 - | Follower |
| q | Only renew complete with selector rod for 5th and 6th gear → Item |
| q | Pulling off → Anchor |
| 7 - | Selector fork for 5th and 6th gear |
| q | Can be renewed individually |
| 8 - | Not fitted |
| 9 - | Selector rod for 5th and 6th gear |
| q | Renew only complete with follower → Item |
| q | Removing → Anchor |
| q | Installing → Anchor |
| 10 - | Locking collar/synchronising hub for 5th and 6th gear |
| q | Removing → Anchor |
| q | Installing → Anchor |
| 11 - | Circlip |
| 12 - | 5th gear wheel |
| q | Pulling off → Anchor |
| q | Pressing on → Anchor |
| 13 - | 6th speed selector gear |
| q | Pull off together with synchronising hub and inner race for 5th gear → Anchor |
| 14 - | Needle bearing for 6th gear |
| 15 - | Thrust washer for needle bearing for 6th gear |
| q | Installation position: groove faces circlip, smooth contact surface towards needle bearing |
| 16 - | Circlip |
| 17 - | Inner race for roller bearing |
| q | Take off by hand → Anchor |
| 18 - | Circlip |
| q | Re-determining thickness → Anchor |
| 19 - | 6th gear wheel |
| q | To press off, remove bearing plate → Anchor |
| q | Pressing off → Anchor |
| q | Pressing on → Anchor |
