A4 Cabriolet Mk2
Selector mechanism - exploded view of components |
Part I |
Note
Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
1 - | Ball |
2 - | Rubber ring |
3 - | Ball guide |
4 - | Rubber ring |
5 - | Washer |
q | Lip points towards ball guide → Item |
6 - | Circlip |
q | Take out before removing ball |
7 - | Spring |
8 - | Spacer sleeve |
9 - | Washer |
10 - | Circlip |
11 - | Noise insulation |
q | -Arrow- marked on noise insulation points in direction of travel |
12 - | Gear lever knob |
q | With boot |
q | Removing and installing → Chapter |
13 - | Nut, 10 Nm |
14 - | Gear lever bearing |
15 - | Torx socket head bolt |
16 - | Gear lever |
q | Bend points towards rear |
17 - | Bolt |
18 - | Nut, 10 Nm |
19 - | Selector housing |
20 - | Joint for gear lever/selector rod |
21 - | Nut, 10 Nm |
q | Self-locking |
q | Renew |
22 - | Bush |
Part II |
Note
Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
1 - | Ball socket |
q | To remove, bend open peened points on selector rod → Item. |
2 - | Washer |
3 - | Ball socket |
q | To remove pull off retaining clip → Item |
4 - | Bellows |
q | Secure to selector rod with commercially available instant adhesive |
5 - | Selector shaft lever |
6 - | Nut, 23 Nm |
7 - | Bolt, 23 Nm |
8 - | Connecting rod |
q | To remove pull off retaining clip → Item |
9 - | Retaining clip |
10 - | Bolt, 40 Nm |
11 - | Push rod |
q | With bush, bolt and washers |
12 - | Hexagon socket head bolt, 23 Nm |
13 - | Washer |
14 - | Ball housing |
15 - | Clamping ring for bellows |
16 - | Bellows |
q | To remove, carefully pull over selector rod → Item and push rod → Item. |
q | When installing, align with markings on selector rod → Item and push rod → Item. |
17 - | Hexagon socket head bolt, 23 Nm |
18 - | Clamp |
19 - | Selector rod |
20 - | Selector fork |
21 - | Nut, 10 Nm |
q | Self-locking |
q | Renew |
22 - | Ball stud |