A4 Cabriolet Mk2
Servicing end cover |
Special tools and workshop equipment required |
t | Thrust plate -VW 401- |
t | Thrust plate -VW 402- |
t | Press tool -VW 412- |
t | Tube -VW 415 A- |
t | Spacer sleeve -VW 472/2- |
t | Thrust ring -2006 A- |
|
|
Exploded view |
1 - | End cover |
q | If renewed, re-determine thickness of circlip → Item |
q | Re-determine shims for Torsen differential → Anchor |
2 - | Oil drain plug, 40 Nm |
3 - | Roller bearing for input shaft |
q | Pulling out → Fig. |
q | Pressing in flush → Fig. |
4 - | Ball bearing for input shaft |
q | Removing → Fig. |
q | Installing → Fig. |
q | If renewed, re-determine thickness of circlip → Item |
5 - | Circlip |
q | Re-determining thickness → Anchor |
q | Installing → Fig. |
6 - | Baffle plate |
q | Renew |
q | Removing → Fig. |
q | Installing and peening in position when renewing ball bearing for input shaft → Fig. |
q | Installing and peening in position when renewing end cover → Fig. |
7 - | Needle bearing for Torsen differential |
q | Pulling out → Fig. |
q | Driving in → Fig. |
|
|
Note
|
Available circlips - Thickness in mm 1) | |||
2.55 | 2.65 | ||
2.60 | 2.70 | ||
|
|
|
|
|
|