–
| Attach counterhold tool -10 - 201- before loosening bolts. |
To prevent the pressure plate from becoming distorted during removal (causes clutch grab when driving off), always adhere to the following procedure when unbolting the pressure plate: |
–
| Loosen all six bolts consecutively in clockwise direction and in steps of 90° (1/4 turn) until the pressure plate is released. |
Note t
| Before you re-install the SAC pressure plate check that it is not distorted → Fig.. |
t
| When only the clutch plate is renewed, the adjuster ring in the SAC pressure plate has to be reset before assembly → Chapter. |
l
| Installation position of clutch plate: coil springs (damper assembly) or marking „Getriebeseite“ point towards pressure plate and gearbox. |
|
|
|