–
| Lightly oil outer circumference of new oil seal. |
–
| Drive in new flange shaft oil seal using thrust piece -T10387- until thrust piece reaches stop; keep seal straight when installing. |
Note t
| Driving-in depth (standard): 5.5 mm beneath surface of housing |
t
| When carrying out a repair, the oil seal is driven in to a depth of 6.5 mm using thrust piece -T10387-, so that the new seal does not bear on the same contact surface on the used flange shaft. |
–
| Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. |
–
| Knock flange shaft in with drift -VW 295-. |
The remaining installation steps are carried out in the reverse sequence; note the following points: |
–
| Check oil level in gearbox and top up with gear oil if necessary → Chapter. |
–
| Install noise insulation. |
|
|
|