Note The centre console does not have to be removed if the procedure described below is followed. |
–
| Using an angle grinder or similar, cut off the locking cable adjustment gauge -3352 A- at the rear end of the flat section -arrow-. |
WARNING |
–
| Order a new locking cable adjustment gauge -3352 A- as a replacement for subsequent use. |
Requirements for adjustment |
l
| Locking cable must be in installation position. |
l
| Selector lever is in position “P” |
l
| Ignition key is in removal position. |
Note The selector lever handle and cover can remain installed. |
|
|
|