audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking torque converter > < Draining torque converter

A4 Cabriolet Mk2

Renewing oil seal for torque converter
Renewing oil seal for torque converter
Special tools and workshop equipment required
   
t  Oil seal extractor lever -VW 681-
  W00-0154
t  Thrust piece -3295-
  W00-0696
Procedure
l  Gearbox is secured to assembly stand → Servicing automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.37, or put down on a flat surface.
–  Apply oil seal extractor lever -VW 681- directly behind the sealing lip of the oil seal to avoid damaging the stop ring located behind it.
–  Pry out oil seal using oil seal extractor lever -VW 681-.
–  Fit stop ring.
  A32-0002
–  Lightly lubricate outer circumference and sealing lips of oil seal with ATF.
l  Installation position: open side of oil seal points towards gearbox
–  Drive in torque converter oil seal with thrust piece -3295- until thrust piece reaches stop.
  A32-0003

Checking torque converter > < Draining torque converter