| –
| Turn sleeve -1- anti-clockwise and push down onto stop. |
| –
| Carefully pull interlock button on selector lever handle -2- out of selector lever handle -3- just far enough to be able to insert a cable tie between interlock button and selector lever. |
Note | Do NOT pull interlock button on selector lever handle out further; otherwise the selector lever handle will be damaged. |
| –
| Use the cable tie to secure the interlock button in its pulled position -arrow-, as shown in the illustration. |
| –
| Remove the selector lever handle by pulling it off to the top. |
| Installation is carried out in reverse sequence; note the following: |
| –
| Shift selector lever to position “D”. |
Note | t
| To install the selector lever handle -3- the interlock button -2- has to be pulled out to the stop and must be secured with either a cable tie -arrow- or with the assembly aid supplied together with the new handle. |
| t
| If, by mistake, the button has not been secured, it must not be pulled out of the selector lever handle using mechanical tools. Position a compressed air gun at the bottom of the handle and carefully press the button out with compressed air. |
| –
| Fit selector lever handle -3- fully onto selector lever; interlock button on selector lever handle -2- points towards the driver. |
| l
| The handle must engage in the annular groove on the selector lever. |
| –
| Remove the cable tie -arrow- or assembly aid, allowing the button mechanism to engage in the vertical groove on the selector lever. |
| l
| The interlock button should automatically retract into the handle. |
Note | If the button does not retract automatically, the handle is not installed correctly. |
| –
| Pull sleeve -1- upwards and engage by turning in clockwise direction. |
| –
| Check function of interlock button on selector lever handle → Anchor. |
|
|
|
