audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing ATF breather pipe > < Removing and installing additional ATF filter on vehicles with 2.0 ltr. normally aspirated engine and 6-cyl. petrol engine

A4 Cabriolet Mk2

Removing and installing additional ATF filter on vehicles with 6-cyl. TDI engine
Removing and installing additional ATF filter on vehicles with 6-cyl. TDI engine
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
Removing
  W00-10211
–  On vehicles fitted with auxiliary heater, remove bolts -arrows- securing exhaust pipe of auxiliary heater to noise insulation.
  A10-0407
–  Loosen bolts/quick-release fasteners -1 ... 3- and detach front and rear noise insulation.
  Note
  A10-1320
Observe rules for cleanliness when working on automatic gearbox → Chapter.
–  Place used oil collection and extraction unit -V.A.G 1782- below gearbox.
–  Unscrew union nut -2- and disconnect ATF pipe.
–  Unbolt clamp for ATF pipes -1-.
–  Detach retainer for ATF pipes on right side of engine.
  A37-0539
–  Remove bolt -arrow- and detach ATF pipes from gearbox.
  A10-0960
–  Unbolt additional ATF filter from gearbox -arrows-.
Installing
Installation is carried out in reverse sequence; note the following:
  Note
Renew O-rings
–  Checking and correcting ATF level → Chapter.
Tightening torques
  A37-0535
ComponentNm
Additional ATF filter to bracket20
Bracket for additional ATF filter to gearbox40
ATF pipes to gearbox21
Clamp to engine5
Union nut for ATF pipe29

   

Removing and installing ATF breather pipe > < Removing and installing additional ATF filter on vehicles with 2.0 ltr. normally aspirated engine and 6-cyl. petrol engine