A4 Cabriolet Mk2
Exploded view - removing and installing differential |
l | Rear final drive removed |
Refer to general repair instructions → Chapter. |
Clamp rear final drive in assembly stand → Fig. |
1) | Adjustment work is required if these components are renewed → Chapter |
1 - | Breather sleeve |
q | With rubber valve |
q | Installation position → Fig. |
2 - | Rear final drive housing → Note |
q | Removing and installing pinion shaft → Chapter |
3 - | Large tapered roller bearing outer race → Note |
q | Removing and installing → Chapter |
4 - | Shim S1 |
q | Note thickness |
q | Table of adjustments → Chapter |
5 - | Cover for rear final drive → Note |
q | With O-ring |
q | Always renew O-ring |
q | Lubricate O-ring with gear oil before installing |
6 - | Torx bolt, 25 Nm |
7 - | Oil seal |
q | Renewing → Chapter |
8 - | Hexagon socket head bolt, 25 Nm |
9 - | Flange shaft |
q | Removing and installing → Fig. |
10 - | Screw plug, 35 Nm |
q | Checking gear oil in rear final drive → Chapter |
q | Capacity and specification → Chapter |
11 - | Differential with crown wheel → Note |
q | Dismantling and assembling → Chapter |
12 - | Oil drain plug, 35 Nm |
13 - | Bush |
q | Holds magnet in position |
q | Drive in onto stop |
14 - | Magnet |
q | Always clean before re-installing |
15 - | Small tapered roller bearing outer race → Note |
q | Removing and installing → Chapter |
16 - | Shim S2 |
q | Note thickness |
q | Table of adjustments → Chapter |
17 - | Oil seal |
q | Renewing → Chapter |
18 - | Flange shaft |
q | Removing and installing → Fig. |
19 - | Hexagon socket head bolt, 25 Nm |
20 - | Cover |
q | Installing → Fig. |
|
|
|
|