t
| Make sure that the marks on the propshaft flange -arrow A- and on the gearbox/final drive flange -arrow B- are in line. |
t
| If a new propshaft is being installed and the factory marking on the rear final drive flange is no longer visible, the radial run-out at the flange for the propshaft must be measured → Chapter, and the coloured marking on the new propshaft must be aligned with the new marking on the flange. |
–
| Gaskets for propshaft on flanges of gearbox and rear final drive must be renewed. Degrease sealing surfaces and glue on new gaskets. |
|
|
|