t
| When installing a new rear final drive unit, check the oil level in the final drive and top up if necessary → Chapter. |
t
| Capacity and specification, Audi A4 2001 ► → Chapter |
t
| Capacity and specification, Cabriolet 2003 ► → Chapter |
t
| Capacity and specification, Audi A6 2005 ► → Chapter |
t
| Capacity and specification, Audi A8 2003 ► → Chapter |
t
| When installing mounting brackets as well as other waxed components, the contact surfaces must be cleaned. The contact surfaces must be free of wax and grease. |
t
| Thoroughly clean all joints and surrounding areas before dismantling. |
O-rings, oil seals and gaskets |
t
| Always renew O-rings, oil seals and gaskets. |
t
| After removing gaskets and seals, always inspect the contact surface on the housing or shaft for burrs resulting from removal or for other signs of damage. |
t
| Thoroughly clean housing joint surfaces before assembling. |
|
|
|