A4 Cabriolet Mk2
| ATF supply unit - exploded view of components |
Note| t | Some of the components shown are supplied as part of an assembly group and cannot be ordered as individual components → Parts catalogue. |
| t | Before assembly, check the individual components of the ATF pump for traces of wear and damage → Chapter. |
| t | Before assembly, check the individual components of clutch “C” for traces of wear and damage → Chapter. |
| 1 - | Oil seal |
| q | Renew |
| 2 - | Corrugated washer |
| 3 - | O-ring |
| q | Renew |
| 4 - | ATF pump housing |
| 5 - | Annulus (outer pump gear) |
| 6 - | ATF pump gear |
| 7 - | Locating sleeve |
| 8 - | Intermediate plate |
| 9 - | O-ring |
| q | Renew |
| 10 - | Housing for ATF supply unit |
| 11 - | Outer plate carrier “C” |
| 12 - | Countersunk bolt |
| q | Tightening sequence → Anchor |
| 13 - | Bolt |
| q | Tightening sequence → Anchor |
| 14 - | Stator shaft |
| q | Removing and installing → Chapter |
| 15 - | Countersunk bolt |
| q | Tightening sequence → Anchor |
| 16 - | Rectangular section seals |
| q | Renew |
| 17 - | Rectangular section seal |
| q | Renew |
| 18 - | Axial needle bearing |
