A4 Cabriolet Mk2
| Sump and balance shaft assembly with oil pump - exploded view of components |
| 1 - | Cover |
| q | For chain sprockets |
| 2 - | 15 Nm |
| 3 - | Chain tensioner |
| 4 - | 20 Nm + 90° (1/4 turn) further |
| q | Renew |
| 5 - | Chain for oil pump and balance shaft |
| 6 - | Dowel sleeve |
| 7 - | Intermediate plate |
| q | Renew |
| q | Removing and installing → Chapter „Removing and installing sump and balance shaft assembly“ |
| 8 - | Balance shaft assembly with oil pump |
| q | Before installing, check that the two dowel sleeves for centring balance shaft assembly/cylinder block → Item are fitted. |
| q | Removing and installing → Chapter |
| 9 - | Suction pipe |
| q | Clean strainer if dirty |
| 10 - | 9 Nm |
| 11 - | O-ring |
| q | Renew |
| 12 - | Oil pipe |
| 13 - | 9 Nm |
| 14 - | O-ring |
| q | Renew |
| 15 - | 15 Nm + 90° (1/4 turn) further |
| q | Renew |
| 16 - | Sump |
| q | Remove together with intermediate plate and balance shaft assembly → Chapter |
| q | Clean sealing surface before installing |
| 17 - | Bolt M10, 40 Nm |
| 18 - | O-ring |
| q | Renew |
| 19 - | With oil level/oil temperature sender -G266- |
| 20 - | Protective cover for oil level/oil temperature sender -G266- |
| 21 - | 10 Nm |
| q | Self-locking |
| q | Renew |
| 22 - | Bolt M7, 15 Nm |
| 23 - | Seal |
| q | Renew |
| 24 - | Oil drain plug, 30 Nm |
| 25 - | 15 Nm + 90° (1/4 turn) further |
| q | Renew |
| 26 - | 15 Nm + 90° (1/4 turn) further |
| q | Renew |
| 27 - | Chain sprocket for oil pump |
| q | Note installation position |
| q | Sprocket can only be fitted on oil pump shaft in one position. |
| q | Removing and installing → Chapter |
|
|
