audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Turbocharger - exploded view > < Turbocharger

A4 Cabriolet Mk2

Fitting hose connections with plug-in connectors
Fitting hose connections with plug-in connectors
  Caution
The seal in the plug-in connector can be damaged if the securing clip is in the locked position when fitting the connector. This can cause leakage. Note assembly instructions.
Removing:
   
–  Release plug-in connector by pulling out retaining clip -arrow-. Disconnect pipe/hose (do not use tools of any kind).
Installing
–  When renewing seal, fit seal in groove on charge air hose. Make sure that the seal is correctly seated in the groove all round the complete circumference and that it is not twisted.
–  Lubricate sealing surface and seal with oil.
  N21-0184
–  Move securing clip to released position -1-.
–  Push charge air hose into connector as far as stop.
–  Move securing clip to locked position -2- and press charge air hose in once again.
–  Then pull hose to check that it is fitted correctly and that plug-in connector is locked.
  N21-10133

Turbocharger - exploded view > < Turbocharger