A4 Cabriolet Mk2
Cylinder head - exploded view |
1 - | Special bolt, 10 Nm |
q | Renew if damaged or leaking |
q | Note correct sequence when loosening → Anchor |
q | Note correct sequence when tightening → Anchor |
2 - | Cylinder head cover |
q | Removing and installing → Chapter |
3 - | Filler cap |
4 - | Seal |
q | Renew if damaged or leaking |
5 - | Gasket for cylinder head cover |
q | Renew if damaged or leaking |
6 - | Cylinder head bolt |
q | Renew |
q | Note correct sequence when loosening → Anchor |
q | Note correct sequence when tightening → Anchor |
7 - | 10 Nm |
8 - | Connecting piece |
9 - | O-ring |
q | Renew |
10 - | 10 Nm |
q | Apply locking fluid when fitting |
q | Locking fluid → Parts catalogue |
11 - | Engine lifting eye |
12 - | Retaining pin |
q | For engine cover |
13 - | Bracket |
14 - | Cylinder head gasket |
q | Renewing → Chapter „Removing and installing cylinder head“ |
q | Installation position: Part No. towards cylinder head |
q | If renewed, refill system with fresh coolant |
15 - | Cylinder head |
q | Removing and installing → Chapter |
q | Checking for distortion → Fig. |
q | Machining limit → Fig. |
q | If renewed, refill system with fresh coolant |
|
|