audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch > < Removing and installing oil cooler

A4 Cabriolet Mk2

Removing and installing oil filter housing
Removing and installing oil filter housing
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
Removing
–  Drain off coolant → Chapter.
–  Remove coolant pipe (top) → Chapter.
–  Remove intake manifold → Chapter.
–  Remove coolant pipe (bottom) → Chapter.
  W00-10211
–  Place used oil collection and extraction unit -V.A.G 1782- under engine.
–  Unscrew the bolts -arrows- and remove oil cooler.
  A17-10072
–  Unplug electrical connector -1-.
–  Unscrew bolts -arrows- and remove oil filter housing.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Renew gaskets, seals and O-rings.
t  Make sure baffle plate is in place before installing oil filter housing.
–  Install oil cooler → Chapter.
–  Install coolant pipe (bottom) → Chapter.
–  Install intake manifold → Chapter.
–  Install coolant pipe (top) → Chapter.
–  Fill up with engine oil and check oil level → Chapter.
–  Fill cooling system → Anchor.
Tightening torque
  A17-10109
ComponentNm
Oil filter housing to cylinder block15 + 90° → Remark → Remark

1)  Renew bolts.
2)  90° equals a 1/4 turn.
   

Checking oil pressure and oil pressure switch > < Removing and installing oil cooler