A4 Cabriolet Mk2
Poly V-belt for alternator, power steering pump and air conditioner compressor |
1 - | 25 Nm |
2 - | Tensioner |
3 - | Poly V-belt |
q | Check for wear |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
q | Removing and installing → Chapter |
q | When installing, make sure it is properly seated on pulleys. |
4 - | 25 Nm |
5 - | Bracket for ancillaries |
q | Removing and installing → Chapter |
6 - | 40 Nm |
q | Install using locking fluid; for locking fluid refer to → Parts catalogue |
7 - | Alternator |
q | Removing and installing → Electrical system; Rep. gr.27 |
8 - | 20 Nm |
9 - | 40 Nm |
10 - | 20 Nm |
11 - | Power steering pump |
q | Removing and installing → Running gear, front-wheel drive and four-wheel drive; Rep. gr.48 |
12 - | 40 Nm |
13 - | Air conditioner compressor |
q | On installation, pay attention to dowel sleeves in bolt holes |
14 - | 25 Nm |
15 - | Vibration damper/pulley |
q | Can only be installed in one position |
q | Removing and installing → Chapter |
16 - | Flange bolts 10 Nm + 90° (1/4 turn) further |
q | Renew → Parts catalogue |
17 - | Idler roller |
q | Secured to bracket for ancillaries |
18 - | Special bolt, 25 Nm |
q | For idler roller |
q | Renew → Parts catalogue |