–
| Pull chain sprocket off crankshaft. |
Note t
| While heating up the new spur gear, monitor the temperature with the temperature gauge -VAS 6519-. |
t
| When the temperature reaches 200°C, you have approx. 4 seconds to fit the spur gear on the crankshaft. |
t
| A higher temperature increases the amount of time available (220°C = approx. 6 seconds). |
t
| Make sure the end of the crankshaft is clean. |
Caution Do not exceed a maximum temperature of 240°C; otherwise the spur gear can become discoloured and distorted. |
|
|
|
|