Measuring radial clearance of conrods |
Special tools and workshop equipment required |
–
| Remove conrod bearing caps. |
–
| Clean bearing caps and bearing journals. |
–
| Place Plastigage onto bearing journal or into bearing shells corresponding to width of bearing. |
–
| Fit conrod bearing caps and tighten to 30 Nm without rotating crankshaft. |
–
| Remove conrod bearing caps once more. |
–
| Compare width of Plastigage with measurement scale: |
l
| Radial clearance (wear limit): 0.08 mm. |
|
|
|