Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing sealing flange (rear) >
< Removing and installing dual-mass flywheel - vehicles with manual gearbox
A4 Cabriolet Mk2
Power unit
4-cylinder TDI unit injector engine (1.9 ltr.; 2.0 ltr. 2-valve), mechanics
Enginecrankshaft group, pistons
Sealing flanges and flywheel
Removing and installing flywheel - vehicles with multitronic gearbox
Removing and installing flywheel - vehicles with multitronic gearbox
Removing and installing flywheel - vehicles with multitronic gearbox
Special tools and workshop equipment required
t
Counterhold tool -10 - 201-
Removing
l
Engine or gearbox removed.
–
Remove damper unit
-arrow-
→ Rep. Gr.13
.
–
Mark installation position of flywheel
-arrow-
on crankshaft.
–
Attach counter-hold tool -10 - 201- in order to loosen bolts.
–
Unbolt flywheel.
Installing
Installation is carried out in the reverse order; note the following:
–
Use new securing bolts.
–
Reverse position of counterhold tool -10 - 201- in order to tighten bolts.
–
Install damper unit
→ Rep. Gr.13
.
Tightening torque
Component
Nm
Flywheel to crankshaft
Bolt length 22.5 mm
60 + 90°
1)
l
1)
Renew bolts.
Power unit
4-cylinder TDI unit injector engine (1.9 ltr.; 2.0 ltr. 2-valve), mechanics
Enginecrankshaft group, pistons
Sealing flanges and flywheel
Removing and installing flywheel - vehicles with multitronic gearbox
Removing and installing sealing flange (rear) >
< Removing and installing dual-mass flywheel - vehicles with manual gearbox