Checking hydraulic valve compensation elements |
Special tools and workshop equipment required |
Note t
| Hydraulic valve compensation elements cannot be serviced. |
t
| Irregular valve noises when starting engine are normal. |
–
| Start engine and run until coolant temperature reaches approx. 80 °C. |
–
| Increase engine speed to approx. 2500 rpm for 2 minutes (perform road test if necessary). |
Note t
| If irregular valve noise disappears but repeatedly re-occurs when travelling short distances, renew oil retention valves. |
t
| The oil retention valves are located below the oil filter bracket → Chapter. |
If the hydraulic valve compensation elements are still noisy, locate the defective element as follows: |
–
| Rotate crankshaft until cam of hydraulic compensation element to be checked faces upwards. The procedure is: |
t
| Vehicles with manual gearbox: push vehicle forwards with 4th gear engaged and ignition switched off. |
t
| Vehicles with automatic gearbox: rotate crankshaft in clockwise direction via central bolt for vibration damper. |
|
|
|