A4 Cabriolet Mk2
Balance shaft - exploded view of components |
1 - | Balance shaft |
q | Removing and installing → Chapter |
2 - | 60 Nm |
q | Use Ø 8 mm drill bit as counterhold when loosening and tightening |
3 - | Balance weight (timing chain end) |
q | Can only be fitted on balance shaft in one position. |
4 - | Bearing plate |
5 - | 13 Nm |
6 - | Balance weight (pulley end) |
q | Can only be fitted on balance shaft in one position. |
7 - | 60 Nm |
q | Use Ø 8 mm drill bit as counterhold when loosening and tightening |