Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing sump (top section) >
< Removing and installing sump (bottom section)
A4 Cabriolet Mk2
Power unit
6-cylinder direct petrol injection engine (3.2 ltr. 4-valve), mechanics
Engine lubrication / Lubrication system
Removing and installing oil pump
Removing and installing oil pump
Removing and installing oil pump
Removing
–
Remove sump (bottom section)
→ Chapter
.
–
Remove bolts
-arrows-
.
–
Detach oil pump from drive shaft by pulling it to front, move drive shaft slightly to rear if necessary.
Installing
Installation is carried out in the reverse order; note the following:
Note
Renew O-rings.
–
Fit oil pump onto drive shaft and tighten bolts.
–
Install sump (bottom section)
→ Chapter
.
–
Fill up with engine oil and check oil level
→ Booklet803
or
→ Booklet805
.
Tightening torque
Component
Nm
Oil pump to sump (top section)
20
Power unit
6-cylinder direct petrol injection engine (3.2 ltr. 4-valve), mechanics
Engine lubrication / Lubrication system
Removing and installing oil pump
Removing and installing sump (top section) >
< Removing and installing sump (bottom section)