A4 Cabriolet Mk2
| Camshaft adjuster - exploded view |
| 1 - | Oil seals |
| q | Renewing → Chapter |
| 2 - | Housing for camshaft control valves |
| 3 - | O-rings |
| q | Between solenoid valves and solenoid valve housing |
| q | Green |
| q | Renew |
| 4 - | O-rings |
| q | Black |
| q | Renew |
| 5 - | O-rings |
| q | Green |
| q | Renew |
| 6 - | 4 Nm |
| 7 - | Camshaft control valve - inlet side |
| q | Cylinder bank 1 (right-side): camshaft control valve 1 -N205- |
| q | Cylinder bank 2 (left-side): camshaft control valve 2 -N208- |
| q | Do not install camshaft control valve for exhaust side on inlet side |
| q | Note identification marking: 12. 100 388 |
| 8 - | Seal |
| q | Renew if damaged |
| 9 - | Connector adapter |
| q | Adapter must be renewed if it has been disconnected from camshaft control valves |
| q | Push carefully onto connectors on camshaft control valves until it engages |
| 10 - | 4 Nm |
| 11 - | Camshaft control valve - exhaust side |
| q | Cylinder bank 1 (right-side): exhaust camshaft control valve 1 -N318- |
| q | Cylinder bank 2 (left-side): exhaust camshaft control valve 2 -N319- |
| q | Do not install camshaft control valve for inlet side on exhaust side |
| q | Note identification marking: 12. 100 389 |
| 12 - | Gasket |
| q | Renew |
| 13 - | 10 Nm |
