audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing flywheel - vehicles with multitronic gearbox 01J > < Removing and installing dual-mass flywheel - vehicles with manual gearbox

A4 Cabriolet Mk2

Extracting and driving in needle bearing for dual-mass flywheel
Extracting and driving in needle bearing for dual-mass flywheel
Special tools and workshop equipment required
   
t  Punch -3264-
  W00-0323
t  -1-Internal puller -Kukko 21/1-
t  -4-Counter-support -Kukko 22/1-
  W00-0633
Procedure
l  Engine or gearbox removed
–  Remove clutch pressure plate → Rep. Gr.30.
–  Remove needle bearing using internal puller -Kukko 21/1- and counter-support -Kukko 22/1-.
  A13-0475
–  Drive needle bearing into dual-mass flywheel using punch -3264-.
  A13-0476
Installation depth for needle bearing -2-:
–  To measure installation depth, place a metal straight-edge on the plastic ring -1- of the dual-mass flywheel.
l  Dimension -x- = 0.5 mm.
  Note
The plastic ring is sensitive to knocks. Renew dual-mass flywheel if plastic ring is damaged.
  A15-0737

Removing and installing flywheel - vehicles with multitronic gearbox 01J > < Removing and installing dual-mass flywheel - vehicles with manual gearbox