–
| Remove nuts -1- and -3- (accessible from below) securing front exhaust pipe to exhaust manifold. |
Note Shown in illustration with engine removed. |
–
| Move Lambda probe wires clear. |
–
| Take out front exhaust pipe with starter and main catalytic converter. |
Installation is carried out in the reverse order; note the following: |
Note t
| Renew gaskets and self-locking nuts. |
t
| Fit all cable ties in the original positions when installing. |
t
| When installing, the Lambda probe wires must always be reattached at the same locations to prevent them from coming into contact with the exhaust pipe. |
–
| Install gearbox supports with gearbox mountings → Rep. Gr.37. |
–
| Align exhaust system so it is free of stress → Chapter. |
Note Components of exhaust pipe mountings on gearbox for vehicles with automatic gearbox 01V → Fig.. |
|
|
|