Audi Workshop Service and Repair Manuals

Securing engine to engine and gearbox support

Special tools and workshop equipment required

t	Shackle -10 - 222 A /12-

t	Hook -3004-

t	Lifting tackle -3033-

t	Engine and gearbox support -VAS 6095- with bracket for V6 TDI engine -VAS 6095/1-4-

t	Workshop hoist -VAS 6100-

t	Lift arm extension (workshop hoist) -VAS 6101-

Procedure l  Engine separated from gearbox → Chapter.   Note For better accessibility with workshop hoist -VAS 6100- it is advisable to remove the sliding bar from scissor-type assembly platform -VAS 6131 A-. –  Attach lifting tackle -3033- to workshop hoist -VAS 6100- as shown in the illustration.

–  Screw a nut -arrow- about 4 turns onto stud on turbocharger. –  Attach lift arm extension -VAS 6101- to workshop hoist -VAS 6100-. –  Connect lift arm extension -VAS 6101- to shackle -10 - 222 A /12- and engage hook -3004- on stud. –  Tension hook -3004- so that engine is taken up horizontally. –  Lift engine off the support elements on scissor-type assembly platform -VAS 6131 A-.

–  Unplug electrical connector -1- at engine mounting (left-side). –  If necessary, move wiring clear at console for engine mounting. –  Remove bolts -arrows- and detach engine support (left-side).

Vehicles with manual gearbox or multitronic gearbox: –  Unplug electrical connector -1- at engine mounting (right-side). –  If necessary, move wiring clear at console for engine mounting. –  Remove bolts -arrows- and detach engine support (right-side).

All vehicles (continued): –  Using support bracket for V6 TDI engine -VAS 6095/1-4-, secure engine to engine and gearbox support -VAS 6095- (40 Nm) as shown in the illustration.