To prevent damage to the dual-mass flywheel when removing, the bolts -B- must not be removed with an impact wrench or similar. The bolts may only be removed by hand using conventional tools. |
–
| Rotate the dual-mass flywheel -A- so that the bolts align with the holes -arrows-. |
–
| When unscrewing the bolts, make sure that the bolt heads do not come into contact with the dual-mass flywheel; the flywheel will otherwise be damaged as the bolts are screwed out. |
Installation is carried out in the reverse order; note the following: |
Note A needle bearing is fitted in the dual-mass flywheel; knock in the needle bearing when fitting a new flywheel → Chapter. |
–
| Use new securing bolts. |
–
| Reverse position of counterhold tool -10 - 201- in order to tighten bolts. |
|
|
|