audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Drive plate - exploded view > < Removing and installing damper unit - vehicles with multitronic gearbox

A4 Cabriolet Mk2

Removing and installing flywheel - vehicles with multitronic gearbox
Removing and installing flywheel - vehicles with multitronic gearbox
Special tools and workshop equipment required
   
t  Counterhold tool -10 - 201-
  W00-0254
Removing
Proceed as follows:
l  Gearbox removed.
–  Remove damper unit → Chapter.
–  Mark position of flywheel on crankshaft for re-installation.
–  Insert counterhold tool -10 - 201- to slacken bolts.
–  Remove bolts -arrow- and remove flywheel.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew bolts for flywheel.
–  Fit counterhold tool -10 - 201- the other way round to tighten bolts.
–  Install damper unit → Chapter.
Tightening torque
  A13-0822
ComponentNm
Flywheel to crankshaft60 + 90° 1)2)
l  1) Renew bolts.
l  2) 90° = one quarter turn.

   

Drive plate - exploded view > < Removing and installing damper unit - vehicles with multitronic gearbox