A4 Cabriolet Mk2
| Turbocharger for vehicles with 2.7 ltr. engine - exploded view |
| 1 - | 30 Nm + 90° |
| q | Type of connection differs depending on version → Fig. |
| 2 - | Intermediate pipe |
| q | Removing and installing: left-side → Chapter, right-side → Chapter |
| 3 - | 30 Nm + 90° |
| q | Renew |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 4 - | Gasket |
| q | Renew |
| 5 - | 25 Nm |
| 6 - | Intermediate flange |
| q | Removing and installing → Chapter |
| 7 - | Seal |
| q | Renew |
| 8 - | Gasket |
| q | Renew |
| 9 - | 9 Nm |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 10 - | Connecting pipe to change-over flap for exhaust gas recirculation cooler |
| 11 - | Gasket |
| q | Renew |
| 12 - | Turbocharger |
| q | With turbocharger 1 control unit -J724- |
| q | Removing and installing turbocharger → Chapter |
| q | Removing and installing turbocharger 1 control unit -J724- → Chapter |
| 13 - | 30 Nm + 90° |
| q | Renew |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 14 - | Gasket |
| q | Renew |
| 15 - | Starter catalytic converter |
| q | Removing and installing: vehicles without particulate filter → Chapter, vehicles with particulate filter → Chapter. |
| 16 - | 23 Nm |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 17 - | Heat shield for turbocharger |
| 18 - | 9 Nm |
| 19 - | Seals |
| q | Renew |
| 20 - | Banjo bolt, 15 Nm |
| 21 - | Oil supply line |
| q | From cylinder block |
| 22 - | 9 Nm |
| 23 - | O-ring |
| q | Renew |
| 24 - | Seal |
| q | Renew if damaged |
| 25 - | 9 Nm |
| 26 - | Connecting piece for air intake hose |
| q | From air mass meter -G70- to turbocharger |
| 27 - | Hose clip, 5.5 Nm |
| q | Reinforced |
| 28 - | Air hose |
| q | From turbocharger to air pipe (right-side) |
| q | Must be free of oil and grease when installing |
| 29 - | Hose clip, 5.5 Nm |
| q | Reinforced |
| 30 - | 9 Nm |
| 31 - | Air pipe (right-side) |
| 32 - | Top section of oil return line |
| From turbocharger |
| 33 - | O-ring |
| q | Renew |
| 34 - | Bottom section of oil return line |
| q | To cylinder block |
| 35 - | 9 Nm |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 36 - | Gasket |
| q | Renew |
|
|
