A4 Cabriolet Mk2
Turbocharger for vehicles with 3.0 ltr. engine - exploded view |
1 - | 30 Nm + 90° |
q | Renew |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
2 - | Gasket |
q | Renew |
3 - | Intermediate flange |
q | Removing and installing → Chapter |
4 - | Seal |
q | Renew |
5 - | Gasket |
q | Renew |
6 - | 9 Nm |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
7 - | Connecting pipe to change-over flap for exhaust gas recirculation cooler |
8 - | 9 Nm |
9 - | O-ring |
q | Renew |
10 - | Gasket |
q | Renew |
11 - | Exhaust gas temperature sender 1 -G235- |
q | Removing and installing → Chapter |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
12 - | 30 Nm + 90° |
q | Renew |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
13 - | Gasket |
q | Renew |
14 - | Starter catalytic converter |
q | Removing and installing: vehicles without particulate filter → Chapter, vehicles with particulate filter → Chapter. |
15 - | 23 Nm |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
16 - | Heat shield for turbocharger |
17 - | 9 Nm |
18 - | Seals |
q | Renew |
19 - | Banjo bolt, 15 Nm |
20 - | Oil supply line |
q | From cylinder block |
21 - | 9 Nm |
22 - | O-ring |
q | Renew |
23 - | Turbocharger |
q | With turbocharger 1 control unit -J724- |
q | Removing and installing turbocharger → Chapter |
q | Removing and installing turbocharger 1 control unit -J724- → Chapter |
24 - | Seal |
q | Renew if damaged |
25 - | 9 Nm |
26 - | Connecting piece for air intake hose |
q | From air mass meter -G70- to turbocharger |
q | Must be free of oil and grease when installing |
27 - | Retaining clip, 5.5 Nm |
q | Reinforced |
28 - | Air hose |
q | From turbocharger to air pipe (right-side) |
q | Must be free of oil and grease when installing |
29 - | Retaining clip, 5.5 Nm |
q | Reinforced |
30 - | 9 Nm |
31 - | Air pipe (right-side) |
32 - | Bracket for turbocharger |
33 - | 20 Nm |
q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
34 - | 25 Nm |
35 - | Oil return line |
q | To cylinder block |
36 - | Gasket |
q | Renew |
37 - | 30 Nm + 90° |
q | Type of connection differs depending on version → Fig. |
38 - | Intermediate pipe |
q | Removing and installing: left-side → Chapter, right-side → Chapter |
|