A4 Cabriolet Mk2
| Timing chain covers - exploded view |
| 1 - | Bolt |
| q | Renew M6 bolts |
| q | Renew bolts securing timing chain cover (bottom) to cylinder head. |
| q | Tightening torque and sequence → Anchor |
| 2 - | Crankshaft oil seal (gearbox end) |
| q | Renewing → Chapter |
| 3 - | Dowel sleeve |
| q | 2x |
| 4 - | Cylinder head gasket (left-side) |
| 5 - | 9 Nm |
| q | Note correct sequence when tightening: left-side → Anchor; right-side → Anchor |
| 6 - | Timing chain cover (left-side) |
| q | Removing and installing → Chapter |
| 7 - | O-ring |
| q | Renew |
| 8 - | Intermediate coolant pipe (left-side) |
| q | Use suitable drift to drive out |
| 9 - | O-ring |
| q | Renew |
| 10 - | 9 Nm |
| q | Note correct sequence when tightening → Anchor |
| 11 - | Timing chain cover (right-side) |
| q | Removing and installing → Chapter |
| 12 - | O-ring |
| q | Renew |
| 13 - | Intermediate coolant pipe (right-side) |
| q | Use suitable drift to drive out |
| 14 - | O-ring |
| q | Renew |
| 15 - | Cylinder head gasket (right-side) |
| 16 - | Dowel sleeve |
| q | 2x |
| 17 - | Timing chain cover (bottom) |
| q | Removing and installing → Chapter |
