Audi Workshop Service and Repair Manuals > A4 Cabriolet Mk2 > Power unit | Direct petrol injection and ignition system (4-cyl. 2.0 ltr. 4-valve turbo) | Mixture preparation system, electronic inj.,Gas | Safety precautions and rules for cleanliness | Removing and installing Lambda probe after catalytic converter G130 and Lambda probe 1 heater after catalytic converter Z29

Removing and installing Lambda probe after catalytic converterG130 and Lambda probe 1 heater after catalytic converterZ29

Removing and installing Lambda probe after catalytic converter -G130- and Lambda probe 1 heater after catalytic converter -Z29-

Removing

Special tools and workshop equipment required

t	Lambda probe open ring spanner set -3337-

–	Unplug connector -2- (brown) for Lambda probe after catalytic converter -G130-.

–	Unscrew Lambda probe after catalytic converter -G130--1- using tool from Lambda probe open ring spanner set -3337-.

Installing

When installing, note the following:

Note

t	Threads of new Lambda probes are already coated with assembly paste; the paste must not get into the slots on the probe body.

t	In the case of a used Lambda probe grease only the thread with high-temperature paste. The paste must not get into the slots on the probe body. High-temperature paste → Parts catalogue

t	When installing, it is important to re-attach the Lambda probe wiring at the same locations to prevent it from coming into contact with the exhaust pipe.

t	Tightening torque: 55 Nm