A4 Cabriolet Mk2
| Part II: Subframe - four-wheel drive |
| 1 - | Subframe |
| q | Removing and installing → Chapter |
| q | Renewing subframe bushes → Chapter |
| q | Renewing rear differential bushes → Chapter |
| 2 - | Bolt with washer |
| q | 55 Nm |
| 3 - | Washer |
| 4 - | Hexagon nut |
| 5 - | Plastic insert |
| q | Supplied as part of bush |
| 6 - | Washer |
| q | Always renew |
| 7 - | Bolt with washer |
| q | 110 Nm + 90° |
| q | Always renew |
| q | Thread in body can be repaired using wire thread insert according to DIN 8140 (Helicoil). The thread insert must be of the same length as the thread in the body. |
| 8 - | Washer |
| q | Only fitted at front |
| q | Grooved side towards body |
| q | Only fitted with hydro-bush |
| q | Discontinued as of week 48/00 when new hydro-bush was introduced in production → Parts catalogue |
| 9 - | Final drive support (front) |
| 10 - | Bolt with washer |
| q | 40 Nm |
| 11 - | Shield |
| 12 - | Bolt with washer |
| q | 25 Nm |
| 13 - | Rear final drive |
| 14 - | Rear cross member |
| 15 - | Bolt with washer |
| q | 40 Nm |
| 16 - | Hexagon nut |
| q | 40 Nm |
| 17 - | Washer |
| 18 - | Bolt with washer |
