A4 Cabriolet Mk2
| Part VII: Wheel bearing housing (aluminium) - four-wheel drive |
| 1 - | Wheel bearing housing |
| q | Vehicles with four-wheel drive |
| q | Removing and installing → Chapter |
| q | Servicing → Chapter |
| 2 - | Wheel bearing |
| q | Removing and installing → Chapter |
| 3 - | Wheel hub |
| q | Removing and installing → Chapter |
| 4 - | Flange bolt |
| q | Always renew |
| q | 200 Nm + 180° |
| q | Tighten to 200 Nm while vehicle is raised; turn through specified angle only when vehicle is standing on its wheels |
| q | Do not loosen more than 90° when vehicle is standing on its wheels |
| 5 - | Drive shaft |
| q | Removing and installing → Chapter |
| q | Servicing (with 100 mm Ø inner joint) → Chapter |
| q | Servicing (with 108 mm Ø inner joint) → Chapter |
| 6 - | Washer |
| 7 - | Self-locking nut |
| q | Always renew |
| 8 - | Shock absorber |
| q | Removing and installing → Chapter |
| q | Note correct installation position → Fig. |
| q | Note different running gear versions; see vehicle data sticker → Anchor |
| q | Defective shock absorbers must always be degassed and drained before disposal → Chapter |
| q | Checking shock absorber following removal → Chapter |
| 9 - | Bolt with washer |
| q | 36 Nm |
| 10 - | Hexagon socket head bolt |
| q | 10 Nm |
| 11 - | Speed sensor |
| q | Routing of wiring → Fig., → Fig. |
| 12 - | Countersunk bolts (4x) |
| q | 80 Nm + 90° |
| q | Always renew |
| 13 - | Bolt with washer |
| q | 150 Nm + 90° |
| q | Always renew |
| q | Suspension must be in unladen position when tightening bolt connections |
