audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing navigation interface R94 > < Overview of fitting locations

A4 Cabriolet Mk2

Removing and installing operating electronics control unit for navigationJ402
Removing and installing operating electronics control unit for navigation -J402-
Special tools and workshop equipment required
   
t  Radio release tool -T10057-
–  Switch off all electrical equipment.
–  Remove ignition key.
Removing
  W00-1042
–  Insert radio release tools -T10057- into slots on operating electronics control unit for navigation -J402- until they engage. Pointed ends of grips must face outwards.
–  Grasp hold of grips on radio release tools -T10057- and pull operating electronics control unit for navigation -J402- out of dash panel.
–  Release and unplug electrical connectors at operating electronics control unit for navigation -J402-.
–  Press release tabs on operating electronics control unit for navigation -J402- and remove radio release tools -T10057-.
Installing
–  Plug in all connectors.
–  Slide operating electronics control unit for navigation -J402- carefully into dash panel and engage it in mounting frame.
–  Perform adaptions on navigation operating electronics control unit -J402- → Vehicle diagnosis, testing and information system VAS 5051.
  A91-0487

Removing and installing navigation interface R94 > < Overview of fitting locations