Audi Workshop Service and Repair Manuals > A4 Cabriolet Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches inside, anti-theft system | Ultrasonic interior monitoring | Removing and installing interior monitor send and receive module 1 G303

Removing and installing interior monitor send and receive module 1G303

Removing and installing interior monitor send and receive module 1 -G303-

Removing

–	To renew control unit, select the “Replacement” function for the appropriate control unit in “Guided Functions” mode → Vehicle diagnosis, testing and information system VAS 5051.

–	Switch off ignition and take out ignition key.

–	Remove rear seat bench → Rep. Gr.72.

–	Unscrew nuts -arrows-.

–	Unplug electrical connector -2-.

–	Detach interior monitor send and receive module 1 -G303--item 1- from floor panel.

Installing

Installation is carried out in the reverse order; note the following:

–	Install rear seat bench → Rep. Gr.72.

Tightening torque

Component	Nm
Interior monitor send and receive module 1 -G303- to body	1.4

Audi Workshop Service and Repair Manuals