Audi Workshop Service and Repair Manuals > A4 Cabriolet Mk2 > Vehicle electrics | Electrical system | Lights, lamps, switches outside | Steering column switch module | Removing and installing turn signal switch E2

Removing and installing turn signal switchE2

Removing and installing turn signal switch -E2-

Removing

–	Remove steering column switch module → Chapter.

Note

Return ring with slip ring must be removed/installed in centre position (wheels in straight ahead position).

–	Carefully release retaining hooks -arrows-.

–	Detach return ring with slip ring -2- with steering angle sender -G85--item 1- from steering column switch module.

–	Unscrew bolts -arrows-.

–	Remove steering column electronics control unit -J527--item 2- and intermittent wiper switch -E22--item 3- from steering column switch module.

–	Detach cruise control system switch -E45--item 1- at steering column switch module.

–	Unscrew bolt -5- and remove retaining clip -4-.

Installing

Further installation is carried out in the reverse order; note the following:

–	Make sure all fasteners and the electrical connectors are properly engaged.

–	Install steering column switch module → Anchor.

Tightening torques

Component	Nm
Steering column switch module to steering column electronics control unit -J527-	0.65
Intermittent wiper switch -E22- to steering column electronics control unit -J527-	0.65
Switch for cruise control system -E45- to steering column electronics control unit -J527-	0.65

Audi Workshop Service and Repair Manuals