audi Workshop Repair Guides

Audi A4 Cabriolet Workshop Service and Repair Manuals

ABOUT US
Unplugging door separating connector (left-side) > < Relay carriers, fuse holders

Removing and Installing Fuse Holder for A4 Cabriolet Mk2

Removing and installing fuse holder
Removing and installing fuse holder
   
Removing
–  With ignition switched off, disconnect earth cable at battery → Chapter.
–  Remove driver's storage compartment → Rep. Gr.68.
–  Unscrew bolts -1- for fuse holder -2-.
–  Detach fuse holder from central tube for dash panel.
–  Disengage wiring harness at central tube for dash panel and move it clear.
  A70-0812
–  Cut open cable tie -1-.
–  Release cover for fuse holder -arrows-.
–  Detach fuses at fuse holder.
  A97-0273
–  Detach retaining strip for connectors -arrows- and take connectors out of fuse holder.
–  Unclip socket -1-.
  Note
Exact assignment of contacts in fuse holder can be found in applicable current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
  Note
All cable ties unfastened or cut open during removal must be reattached in same position when installing.
–  Connect battery. Steps required → Anchor.
–  Install driver's storage compartment → Rep. Gr.68.
Tightening torque
  A97-0274
ComponentNm
Fuse holder to central tube for dash panel3

   

Unplugging door separating connector (left-side) > < Relay carriers, fuse holders