Audi Workshop Service and Repair Manuals

• ‒ As a check, dimension a =9 mm can be marked on window in length of B-pillar with a water soluble pen.
• ‒ → Adjust window in mount at window lifter.
• ‒ Raise window until shortly before stop.
• ‒ Window -1- and seal -4- for door component carrier must run parallel in roof and A-pillar area.
• ‒ Press window -1- towards B-pillar -3-.

Note:

Window -1- must enter 9 mm-dimension a- into seal -4- for door subframe -3-.

• ‒ Tighten bolts on window lifter mounts.
  Tightening torque 6.5 Nm.
• ‒ Raise window -1- as far as it will go.
• ‒ Check dimension -a- and erase pen mark.