audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing lumbar support > < Converting lumbar support and retrofitting plastic inlay

A4 Mk1

General Body Assembly, Interior (Repair groups 68, 69, 70, 72, 74)
Front seats
Removing and installing Bowden cable for lumbar support adjustment motor
 
A72-0477
  • Bowden cable for lumbar support adjustment motor
  • ◆ Removing
    • ‒ Remove seat => Page72-4
    • ‒ Remove seat side panel (memory seat, electric seat) on sill side
    • ‒ Remove seat side panel (memory seat, electric seat) on tunnel side
    • ‒ Remove backrest cover panel
    • ‒ Remove the backrest (memory seat, electric seat)
    • ‒ Remove side panels
 
A72-0477
    • ‒ To be able to slide up the anti-squeak pad -4-, press the cable clip -5- together and pull out the cable clip -5-.
    • ‒ Detach wire clip -7- at bottom left and right out of the backrest frame -9-.
    • ‒ Detach wire clip -7- at bottom out of the clips -8- (3x).
    • ‒ Fold wire clip -7- and the protective mat -6- upwards.
    • ‒ Detach Bowden cable -1- at the retaining tab -2- and at the guide roller -3-.
  • ◆ Installing
    • ‒ Install Bowden cable for lumbar support adjustment motor -1- in reverse order.
  • Retaining tabs
 
A72-0477
  • Idler roller
  • Anti-squeak pad
  • Cable clip
  • Protective mat
  • Bracket
  • Clip (3x)
  • Backrest frame

Removing and installing lumbar support > < Converting lumbar support and retrofitting plastic inlay